If a word has been entered poorly or was recognized incorrectly by Transcriber, you can go to the Transcriber correction window to fix the problem. First, select the word that was incorrectly recognized (the fastest way is to double-tap it). Then open the correction window by drawing the Correction gesture, as shown previously; by drawing the Quick Correct gesture and then selecting Go To Corrector from the menu; or by tapping the correction icon on the Transcriber toolbar (which appears as a red check mark over a page of writing).The correction window will display a larger version of the word that you selected. You can correct an incorrect word by inputting directly over the letter or letters to change them. Alternatively, you can select an entire word and tap the alternates icon (appears as an uppercase A with a bar underneath it) in the new toolbar that is at the top of the screen.
The Alternates menu that pops up when you double-tap the word is shown in the following illustration. In this menu you can select a replacement for the wrong word from a list of dictionary words, add this word to the dictionary, change the case of the selected letter, add a space, or cancel to close the menu.The fourth icon from the left on the top toolbar allows you to switch the correction window from full-screen mode to partial screen. In partial screen you can still see your whole document while the correction window floats in the front.

You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.